Description
OEM by Gately Audio
This listing is for an LOADED 2 x 12″ , 3.5 Cu Ft Enclosure with 58.6″ of port area.
The enclosure measures 34″ W X 17.125″ H x 17″ D. It is made out of .75″ Russian Baltic Birch and has a stained exterior finish.
This enclosure is tuned to 32hz and has an estimated bandwidth of 25-64hz. This is estimated as there is amplifier tuning and other factors that will take place to final sound reproduction.
This enclosure was developed to run our highly sought after HDS series subwoofers.
Cutout: 11.25″ Mounting Depth: 11.12″
Boxes may come with small imperfections due to the manufacturing process. BOXES THAT ARE NOT IN STOCK – Can be made to order. But please allow a 3-4 week production time. Can be faster at times, depending on season.
SUBWOOFER INFORMATION
The Heavy Duty Street 3.2 Series 1200W Subwoofer improves on its predecessor in terms of build, sound quality, heat dispersion, and frequency response. The 10, 12, or 15-inch models are available with dual 2 or 4-ohm voice coil.
The HDS3.2 series is a perfect option for elevating your daily-driver car audio system build to the next level. First, choose a sealed, ported, or band-pass enclosure. Once you decide on an enclosure option, pair your sub(s) with the appropriate S Series monoblock amp. From there, enjoy easy wiring in series or parallel thanks to the 10 AWG push terminals. Soon you’ll be on your way to a dramatically enhanced listening experience.
As with any SoundQubed subwoofer, proper break-in is key to enjoying long life from your HDS3.2. Make sure you follow the steps to loosen up the suspension before pushing these subs to the limit.
The HDS3.2 1200W Subwoofer
The dual-magnet motor features a bumped T-yoke for greater travel and better heat resistance. Additionally, the vented, electroplated back plate gives heat a way out and decreases turbulence in the coil gap. The HDS3.2 series uses a 3-inch diameter, four-layer, copper dual voice coil with a conical back plate for long-distance travel.
The HDS3.2 series feature cast aluminum frames. This upgrade provides better heat sinking and increased excursion over stamped-steel baskets. A softer three-piece spider system achieves enhanced performance and lower tuning. As a result, the HDS3.2 has an F(s) of 28.26 Hz compared to 35 Hz for the HDS3.1.
An Extended Range of Motion (EROM) surround profile keeps your cone diameter as large as possible while allowing for long, controlled excursion. The EROM profile gives you more cone area, greater stiffness, and lower mass for more accurate coil signal response. The HDS3.2 has a non-pressed, fiber added cone for maximum rigidity and long life.
RMS POWER = 2400watts RMS
MAX Power = 4800 watts RMS
Package includes
(2) Soundqubed HDS3.212-D4 Subwoofers
(1) Soundqubed 2 X 12″ CuFt Subwoofer Enclosure
